Preparing The Mvme712M Module; Dte/Dce Configuration Select Headers; Table 2-1. Serial Port Jumpers/Headers - Motorola MVME712C Installation And Use Manual

Preparing and Installing the Hardware

Preparing the MVME712M Module

2

DTE/DCE configuration select headers

2-2
The locations of the headers, LEDs, terminators, and connectors for the
MVME712M are shown in
and is shipped with factory-installed jumpers that configure the
MVME712M to provide the system functions required for a VMEbus
system.
The factory default configurations are shown in the following paragraphs
with descriptions of each header. The module is operational with the
factory-installed jumpers.
Serial ports 1 through 4 can be configured as a modem (DCE) for
connection to terminal or configured as a terminal (DTE) for connection to
modem. The MVME712M is shipped with the ports configured for DTE
operation.
The following table lists the serial ports with their corresponding jumper
headers.

Table 2-1. Serial port jumpers/headers

Board
Serial Port
Connector
Port 1 J7
Port 2 J8
Port 3 J9
Port 4 J10
Figures 2-2 through 2-9
transition module with the interconnections and jumper settings for
DCE/DTE configuration on each serial port.
Figure 2-1. The module has been factory tested
Panel Connector
Serial port 1/ Console
Serial port 2/ TTY
Serial port 3
Serial port4
illustrate the VME module and MVME712M
Computer Group Literature Center Web Site
Jumper Header
DCE/DTE
J1/J11
J16/J17
J13/J14
J18/J19