Table of Contents
Advertisement
MERCHANDSERS OPERATION AND SERVICE MANUAL/ Rev. JUN. 2015
4.4
ELECTRICAL CONNECTIONS
Refer to the amperage data in this manual, or on data plate, and your local code or the
National Electrical Code to be sure unit is connected to the proper power source. Verify
correct incoming voltage according to the Data Plate information.
Do not, under any circumstances, cut or remove the ground prong from the power
cord. Fagor units must be properly grounded.
NEVER USE AN EXTENSION CORD! Fagor will not warranty any unit that has been
connected to an extension cord.
Fagor equipment must be grounded and connected in accordance with NEC Article
422Appliances.
DANGER:
Power must be turned off and disconnected from the power source whenever
performing maintenance, repair or cleaning the condensing unit.
If machine is still running when power is off, disconnect power at the circuit
breaker before unplugging the machine.
WARNING:
Machine and compressor warranties are void if failure is due to improper
electrical installation.
4.5
SHELVING INSTALLATION
Hook shelf rails onto shelf pilasters
Position all shelf rails equal in distance from the floor for level shelves
Wire shelves are oriented so that cross support bars are facing down
Note: Single door Reach-in include an air flow guard on the rear of the shelves as well as a lip to
maintain an air space at the rear of the cabinet
Place shelves on shelf clips, making sure all corners are seated properly
www.fagorcommercial.com
Page11
Advertisement
Table of Contents
