Assembly Of Main Barbecue - Beef Eater SL5000S Assembly And Operating Instructions Manual

ASSEMBLY OF MAIN BARBECUE

Before You Start
Note the tools you will need before you begin�
Remove any protective plastic from stainless steel
components�
Check for damaged or missing parts, and consult your
retailer if necessary�
Allen Key Adjustable
(provided) spanner/
wrench
Attach The Side Shelves
(Trolley-Mount Models Only)
Attach the two top side shelves using the four screws
provided with each side shelf kit� You do not need any nuts,
as the screws go directly into threaded holes in the cart�
If you have an optional lower side shelf, attach it to the side
panel using 4 screws, washers and nuts�
Lower side shelf - use the
side holes, screws, washers
and nuts�
Side Burner Parts
Assemble the side burner parts as shown�
The first burner disk should locate onto two notches on the
side burner (inside arrows)�
Also, the two notches on the bottom of the trivet line up with
the holes on the side burner (outside arrows)�
Phillips head
screwdriver
Fit The Heat Reflectors
The reflectors fit between each burner� They reflect heat
from the burners, upwards to the cooking surfaces�
The tabbed ends of the heat reflectors face forward to the
front of the barbecue frame� The tabs fit into the slots in the
front end of the barbecue behind the control panel�
Top side shelf - use the
The back of the reflectors rest on the rear of the barbecue
front holes, screws only
frame�
ASSEMBLY OF MAIN BARBECUE
5