Input Source Selection (Rgb(Pc Digital), Rgb(Av Hdcp)) - Sanyo PLC-XU88W Owner's Manual

Input Source Selection (RGB(PC digital), RGB(AV HDCP))

Direct Operation
Choose Computer 1(Digital) by pressing the INPUT button
on the top control or press the COMPUTER button on the
remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point
frame pointer to the Input Menu icon.

Use the Point
▲▼
pointer to Computer 1 (Digital), and then press the
SELECT button.

After the Source Select Menu appeared for Computer 1
(Digital), move the pointer to RGB (PC digital) or RGB
(AV HDCP), and then press the SELECT button.
Notes:

• HDCP (High-bandwidth Digital Content Protection) is
a system for protecting digital entertainment content
delivered by DVI (Digital Visual Interface) from being
copied. The specification of HDCP is decided and
controlled by Digital Content Protection, LLC. Should the
specification be changed, this projector may not display
the digital content protected by HDCP.
• Wired and Wireless are for the Network function. See
owner's manual "Network Set-up and Operation" .
• When the Input Search function is set to "On1" or "On2",
the input signal will be searched automatically (p.50).
• When Monitor out is selected in the Terminal function
(p.50), Computer 2 is not displayed.
0
buttons to move the red
◄►
buttons to move the red arrow
Top Control
INPUT button
Computer 1 (Analog)
Computer 1 (Digital)
Remote Control
COMPUTER button
Computer 1 (Analog)
Computer 1 (Digital)
Input Menu icon
Input Menu
Computer
1
Computer Input
Computer 
Video
wired
wireless
Computer 
Move the pointer
( r e d a r r o w ) t o
Computer 1 (Digital)
a n d p r e s s t h e
SELECT button.
Move the pointer to
the source that you
want to select and
press the SELECT
button.