Door Lock - Midea MFH180-G1302DS F01E-US Technical Service Manual

To remove the control board assembly:
1. Remove the control panel. (See
2. Pull the cycle knob off.
3. Remove the Phillips-head screws that hold the
control board assembly to the control panel.
4.
Release the hook and remove the control
board assembly from the control panel

Door Lock

.)
Control Panel
The door lock contains a door switch and solenoid
operated locking and unlocking mechanism. A
release
manual unlocking of the door.
The door locks when a cycle is entered (Wake-up
routine) and during every cycle. The door unlocks at
the completion of a cycle.
The door will not open when:
•
•
•
Specifi c failures associated with the door lock
can initiate error codes E30 thru E30. (See
Test Mode
The door lock is held to the front panel with
Phillips-head screws. The door lock is accessed from
the front of the washer when the right side of the
gasket is partially pulled back.
To remove the door lock :
1.
– 33 –
hook, located at the middle, allows for
The water level is higher than
Water temperature is above
Wash basket is rotating
.)
Remove the 2 Phillips-head screws that hold the
door lock to the front panel.
main wash level
160°F (71°C)
Service
2
(Continued Next Page)