Table of Contents
Advertisement
11.
Screw locknuts onto the supplied leveling legs.
Turn the nuts toward the bottom and against
the rubber part of the leg.
13.
Stand the washer or dryer upright. Move it close
to its fi nal location.
14.
Make sure that the washer or dryer is level by
placing a spirit level on top. Check side to side
and front to back.
15.
Use an open end or adjustable wrench to adjust
the legs in or out. Tighten the locknuts against
the bottom of the pedestal.
Note: To minimize vibration, the locknuts must be
tight.
16.
Ensure that the slides are closed, then slide the
drawer into the opening.
17.
Align the drawer supports to the slides on each
side.
18.
Reinstall the original screws in each drawer
slide.
Note: The drawer should slide smoothly when you
push it closed.
19.
Remove the 4 shipping screws from the back of
the washer.
Note: Refer to the washer or dryer installation
instructions to complete the installation.
– 21 –
Hide quick links:
Advertisement
Table of Contents
