Table of Contents
Advertisement
3.
Remove the belt by turning the tub drive pulley
and rolling the belt off the pulley.
Belt
Note: The belt is elastic and is designed to be
removed and installed in this manner.
4.
Remove the
/
-in. bolt from the threaded plate
1
2
that holds the motor arm to the outer tub.
Slot
Plate
Note: The threaded plate can fall out of the
recessed slot in the motor mount. Ensure this plate
is reinserted in the slot upon reassembly.
Note: When reinstalling bolt, apply Locktite (Part #
WX5X1005) to bolt threads. Ensure motor arm is at
lowest position under motor bolt before tightening.
5.
Rock motor rearward to clear the motor mounts
from the outer tub. Place the motor on the
washer chassis.
6.
Disconnect the motor wire harness.
Tub Drive
Pulley
7.
Press the lock tab and remove the motor ground
wire.
8.
Remove the plastic wire tie that holds the motor
wire harness and ground wire to the motor.
9.
Remove the motor.
Note: When reinstalling the belt, ensure the belt
is positioned to track in the 7 outer grooves of the
motor pulley.
– 48–
(Continued Next Page)
Hide quick links:
Advertisement
Table of Contents
