Midea MFH180-G1302DS F01E-US Technical Service Manual page 38

The overfl ow water level is approximately 5.5 inches
above the door opening. Overfl ow protection will
occur at this water level.
Overf ow Water Level
Operation of the water level control can be checked
by using service test mode t06. (See
.)
Mode
Specifi c failures associated with the water level
control can initiate error codes E23
.)
Service Test Mode
To remove the water level control:
1.
2.
3.
Note: The pressure tube is diffi cult to remove.
Pull the bottom of the water level control outward,
rotate it
spring.
Service Test
and E65. (See
Water Valve
The water valve assembly consists of
and
rate of 2.1 gallons (8 liters) per minute. It is inserted
and retained in a cutout in the rear of the cabinet
and held in place by a single 6-mm hex-head screw.
It is only available as a complete assembly.
Each solenoid coil has an approximate resistance
value of 1.1K Ω.
Specifi c failures associated with the water valve
can initiate error codes E10. (See
– 41–
Remove the top panel. (See
Press down the single tab, then disconnect each
of the 1 wire harness.
Remove the pressure tube.
a. Squeeze the clamp and slide it back.
b. Carefully break the hose loose by inserting a
small fl at-blade screwdriver under the hose
to break the seal.
c. Remove the hose.
/ -turn clockwise to clear the suspension
1
4
3 solenoid coils. The water valve has a flow
.)
Top Panel
Tab
Pressure Tube
2 valve body
Service Test Mode.)
(Continued Next Page)