To stack the dryer:
Caution: Do not lay dryer on its back. Use the
packing material or a protective surface when
laying dryer on its side.
1.
Carefully lay the dryer on its side.
2.
Use an open end wrench or pliers to remove the
4 dryer leveling legs from the leg brackets.
Leg bracket
Back out and remove
all 4 leveling legs
3.
Remove the adhesive backing and fi rmly place
the 4 rubber pads over the leg brackets.
4.
Align the holes in the left bracket with the holes
in the bottom left corner of the dryer. Attach
the bracket using 2 (#5.5*22mm) Phillips-head
screws.
5.
Align the holes in the right bracket with the holes
in the bottom right corner of the dryer. Attach
the bracket using 2 (#5.5*22mm.) Phillips-head
screws.
– 23 –
(Continued Next Page)