Brother DC200 Operation Manual page 28

d
Firmly attach all of the material to the mat so
that there are no wrinkles and no part can curl
off.
• Otherwise, curls in the material may become
caught when the mat is inserted.
Note
• If the mat is dirty, clean it. For details, see
"Cleaning the Mat" on page 53.
 Peeling Off the Material (Paper)
After cutting the material, use a spatula to slowly
peel off the paper.
a Spatula
■ Fabric (Other Than for Quilt Piecing)
 Attaching Fabric Material (Excluding
Quilt Piecing)
Iron the specially designed contact sheet to the
back of fabrics (excluding quilt piecing) and then
attach them to the standard mat.
The double-faced adhesive type of the iron-on
fabric appliqué contact sheet reinforces the fabric
and enables any pattern to be cut easily,
including appliqués.
The sheet cannot be removed once it has been
attached to the back of fabrics.
For Quilt Piecing, use the high tack adhesive
fabric support sheet and avoid using the iron-on
fabric appliqué contact sheet.
a
a
a
a Standard mat
b Iron-on fabric appliqué contact sheet (white
backing)
Note
• The contact sheet may not adhere to a fabric
surface that is rough that the two surfaces
cannot be heat-set to adhere to each other.
Peel off the protective sheet from the adhesive
side of the standard mat.
1
b
27