Installing And Uninstalling The Holder - Brother DC200 Operation Manual

Installing and Uninstalling the Holder

After adjusting the blade extension, install the holder
in the machine. For the blade extension appropriate
for the material, see "Adjusting the Blade Extension"
on page 32.
a
Press in the operation panel to turn on the
machine.
For details, see "Turning On/Off the Machine" on
page 6.
Note
• Be sure to turn on the machine before installing
the holder.
• If the holder is installed while the machine is off,
the blade may break and material may not be
cut cleanly.
b
If the holder lock lever is not raised, raise it.
The holder cannot be installed if the lever is lowered.
a
a Holder lock lever
CAUTION
• Please remove protective cap from blade
holder before placing it into the machine
carriage.
• Do not allow infants/children to put the
protective caps in their mouths.
c
Grasp the holder grip, and then insert the
holder into the carriage.
a Grip
34
d
Push down on the holder lock lever.
Firmly push down until the holder is locked in place.
e
Reverse the installation procedure to uninstall
the holder.
• After removing the blade holder from the
• Do not leave the blade extended. Otherwise,
• Do not allow infants/children to put the
a
CAUTION
machine, be sure to retract the blade into the
holder and attach the protective cap.
injuries may result.
protective caps in their mouths.