Table of Contents
Advertisement
5
Check that [WPS-PBC] is selected and
then press the <ENTER> button.
6
Select [Yes] and then press the
<ENTER> button.
Memo
● If [No] is selected, the screen returns to that from
step 5.
7
When [Running pushbutton
method...] is displayed, press and hold
the push button on the access point of
the Wireless LAN for several seconds
then release it.
Note
● [Running pushbutton method...] is displayed for
about two minutes. Press and hold the push button
on the access point of the Wireless LAN while it is
displayed.
● For the position of the push button on the access
point of the Wireless LAN and how long it should be
held pressed, refer to the operation manual for the
access point of the Wireless LAN.
● While [Running pushbutton method...] is
displayed, the printer cannot be operated.
● When [WPS Connection successful is displayed,
this equipment is connected to the wireless LAN.
Memo
● If [Timeout] is displayed, it is possible that the
access point of the connection destination could not
be found within the time limit. Redo from step 6.
● If [Overlap] is displayed, WPS-push button is being
executed on 2 or more access points. Please wait for
a short time and then retry.
- 59 -
Connecting to a Computer
3
Advertisement
Table of Contents
