Extech Instruments HDV600 User Manual page 9

Reset button
If the monitor becomes unresponsive due to an EMI field or other magnetic event, use a paper
clip or other pointed object to press the RESET button located on the bottom panel
Rear stand
The rear stand can be set to three positions. Lower (stored), middle position for bench viewing
and upper position for hanging.
FCC Information
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may cause
undesired operation.
Battery Replacement
The charging circuit is designed only for the lithium battery included with the meter. The meter
should be returned to one of our repair facilities for replacement. Non-approved lithium battery could
cause damage to the instrument or hazard to the users.
Safety: Please dispose of batteries responsibly; never dispose of batteries in a fire, batteries may
explode or leak. If the meter is not to be used for 60 days or more, remove the battery and store
separately.
Never dispose of used batteries or rechargeable batteries in household waste.
As consumers, users are legally required to take used batteries to appropriate collection
sites, the retail store where the batteries were purchased, or wherever batteries are sold.
Disposal: Do not dispose of this instrument in household waste. The user is obligated to take end-of-
life devices to a designated collection point for the disposal of electrical and electronic equipment.
9
HDV600-en-GB_V3.0 1/18