Projecting; Selecting The Input Signal; How To Adjust The State Of The Image - Panasonic PT-VW340 Series Operating Instructions (Functional Manual)

Projecting

Check the connections of the peripheral devices and connection of the power cord (
Æ
( page 42) to start the projector. Select the image and adjust the state of the image.

Selecting the input signal

Select an input signal.
1) Press <COMPUTER 1>, <COMPUTER 2>, <HDMI>, <VIDEO/S-VIDEO>, <MEMORY VIEWER>, <Miracast> or
<Panasonic APP> button on the remote control or <INPUT SELECT> button on the control panel.
f The image of the signal being input in the selected terminal is projected.
f You can check the input source through [DETAILED] / [SIMPLE] under the [DISPLAY OPTION] → [ON-SCREEN
DISPLAY] → [INPUT GUIDE] menu.
f You can also select the input source by pressing asqw on the [DETAILED] screen.
Attention
f Images may not be projected properly depending on the connected device and DVD, video tape, etc. to be played. Set the
[PICTURE] menu → [RGB/YC
f Check the aspect ratio of the screen and the image and select the optimum aspect ratio under the [POSITION] menu
Æ
( page 66).

How to adjust the state of the image

If the projected image or the position is not correct when the positioning of the projector and the screen is correctly installed,
adjust the focus and zoom.
1) Adjust the projection angle.
f Install the projector on a flat surface and parallel to the screen so that the projected screen is rectangular.
f If the screen is tilted downward, extend the adjustable feet and adjust the projection screen so that the projected screen
is rectangular.
f For details, see "Adjusting adjustable feet" (
2) Adjust the zoom and the focus.
f Rotate the zoom ring to zoom in and out the image.
f Rotate the focus ring to adjust the focus of the projected image.
Note
f It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f If you adjust the focus, you may need to adjust the size of the image by turning the zoom ring again.
f If keystone distortion occurs, see the [POSITION] menu → [KEYSTONE] (
44 - ENGLISH
Chapter 3 Basic Operations - Projecting
[DETAILED] input guide
Æ
C ] or [RGB/YP P ] ( page 62).
B R B R
Æ
page 34).
Æ
pages 35 - 40) and switch on the power
[SIMPLE] input guide
If there is no signal input
([COMPUTER1], [COMPUTER2] or
[HDMI]), this screen will be displayed.
Check the output settings of your
computer.
Zoom ring
Focus ring
Æ
page 63).