[Projector Setup] Menu; [Status]; [Computer2 Select]; [Projector Id] - Panasonic PT-VW340 Series Operating Instructions (Functional Manual)

[PROJECTOR SETUP] menu

On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (
fAfter selecting the item, press asqw to set.

[STATUS]

You can check the using status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
[SIGNAL]
[RUNTIME]
*
1
[SERIAL NUMBER]
*1 The following conversion is required to calculate the rough estimate for lamp replacement.
A ×1 + B × 0.8 + C × 2/3
f A : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [NORMAL]
f B : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO1]
f C : Runtime which is displayed in [STATUS] screen - [RUNTIME] - [LAMP] - [ECO2]

[COMPUTER2 SELECT]

Set whether to use the <COMPUTER 2 IN/1 OUT> terminal.
1) Press as to select [COMPUTER2 SELECT].
2) Press qw to switch the item.
f The items will switch each time you press the button.

[COMPUTER2 IN]

[COMPUTER1 OUT] Outputs the signal which have been input <COMPUTER 1 IN> terminal.
Note
f The [COMPUTER2 SELECT] will be unavailable when COMPUTER2 is selected as input source.

[PROJECTOR ID]

The projector has an ID number setting function that can be used when multiple projectors are used side by side to enable
simultaneous control or individual control via a single remote control.
1) Press as to select [PROJECTOR ID].
2) Press the <ENTER> button.
f The [PROJECTOR ID] screen is displayed.
74 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
Æ
page 54) for the operation of the menu screen.
[NAME]
[FREQUENCY]
[PROJECTOR]
[NORMAL]
[LAMP
[ECO1]
(ET-)]
[ECO2]
[PROJECTOR]
Formula for lamp replacement time (rough estimate)
When input the computer signal.
Displays the name of input signal.
Displays the scanning frequency of input signal.
Displays the current usage time of projector.
Displays the operation time of lamp in each mode (NORMAL/
ECO1/ECO2). It may differ from the actual runtime under the
each setting of [NORMAL]/[ECO1]/[ECO2] in [LAMP POWER]
menu. And, displays the model no. of the replacement lamp unit
for this projector.
Displays the serial number of the projector.