Advertisement
Pre-installation
1. Carefully unpack the screen.
2. Always handle the screen in a leveled position on a clean surface.
INSTALLATION
Flush Wall Mounting
1. Measure the distance between the keyholes located on the back of the end cap
2. Mark the location of where the screen is to be installed for the pre-drilled hole.
3. After marking the area and drilling the hole, insert the proper screw into the drilled hole and leave
about 1/8" of an inch from the wall to mount the screen.
4. Mount your screen from the keyhole located on back of screen's left and right end cap.
Back of end cap
Front view
060817-DR
Manual Pull-Down Projection Screen
Elite Manual Series
USER'S GUIDE
www.elitescreens.com
Side view
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Elite Screens M135XWV2
Summary of Contents for Elite Screens M135XWV2
- Page 1 Manual Pull-Down Projection Screen Elite Manual Series USER’S GUIDE Pre-installation 1. Carefully unpack the screen. 2. Always handle the screen in a leveled position on a clean surface. INSTALLATION Flush Wall Mounting 1. Measure the distance between the keyholes located on the back of the end cap 2.
- Page 2 Flush Ceiling Mounting 1. Measure the distance between the top screw holes located on the top of the end caps. 2. Mark the location of where the screen is to be installed for the pre-drilled hole. 3. Drill your hole, use a hollow wall anchor if needed 4.
- Page 3 1. Pull the screen down from the lanyard or from the handle only in a 90-degree angle. Do not attempt to pull the screen down by the surface or touch the screen, as it will damage the screen and void the warranty. Note: An internal auto-lock mechanism system will cause the screen to stop and lock on the position at intervals.
Need help?
Do you have a question about the M135XWV2 and is the answer not in the manual?
Questions and answers