Helpful Functions Set During Installation ("Prj" Menu); Auto Power Off Function; Auto Restart Function; Computer2 Select - Sharp Conference Series Operation Manual

Helpful Functions Set during Installation ("PRJ" menu)

Picture Audio
Auto Power Off
Auto Restart

COMPUTER2 Select

STANDBY Mode

RS-232C
Fan Mode
Sysem Lock
®
DLP Link™
®
DLP Link™ Invert
Memory Menu
Rotate Indicator
All reset
Lamp Timer (Life)
SEL./ADJ.
RETURN

1 Auto Power Off Function

Selectable
items
On The projector automatically enters
the standby mode when no input
signal is detected for 15 minutes or
longer.
Off The Auto Power Off function will
be disabled.
Note
• When the Auto Power Off function is set to
"On", 5 minutes before the projector enters the
standby mode, the message "Enter STANDBY
mode in X min." will appear on the screen to
indicate the remaining minutes.

2 Auto Restart Function

Selectable
items
On If the power cord is unplugged
from the outlet or the breaker
switch is turned off when the
projector is on, then the projector
automatically turns on when the
power cord is plugged into the AC
outlet or the breaker switch is
turned on.
Off The projector does not turn on
automatically when the power
cord is plugged into the AC outlet
or the breaker switch is turned on.
56
SIG SCR PRJ Net.
On
On
Monitor Output
Standard
9600bps
Normal
Disable
Off
On
[ 0]h [ 0] min ( 100%)
ENTER
END
Description
Description
Menu operation n Page
3 COMPUTER2 Select
You can also use the MONITOR OUT terminal
as the COMPUTER/COMPONENT 2 terminal.
Select whether to use the terminal as an input
terminal or output terminal.
Selectable items
Input The terminal can be used as an
input terminal (COMPUTER/
COMPONENT 2).
Monitor Output The terminal can be used as an
output terminal (MONITOR OUT).
Note
• Set this before connecting the external
equipment.
• The setting cannot be changed when Input
mode is "COMPUTER 2".
4 STANDBY Mode
When set to "Eco", power consumption is
reduced in Standby mode.
Selectable items
Eco The monitor output, RS-232C and
Network functions are switched off in
Standby mode.
Standard The monitor output, RS-232C and
Network functions are activated even
if the projector is in Standby mode.
5 Selecting the Transmission
Speed (RS-232C)
Make sure that both the projector and com-
puter are set for the same baud rate.
Selectable items
Transmission speed is slow.
9600 bps
38400 bps
115200 bps Transmission speed is rapid.
Note
• Refer to the "SETUP MANUAL" contained on
the supplied CD-ROM for RS-232C
Specifi cations and Command Settings.
• Refer to the computer's operation manual for
instructions for setting the computer's baud rate.
46
Description
Description
Description