Keylock Function; Dlp ® Link Tm; Dlp ® Link Tm Invert - Sharp Conference Series Operation Manual

Helpful Functions Set during Installation ("PRJ" menu)
(Continued)
5 5
Enter the same keycode in "Re-
confi rm".
Note
To cancel the keycode that you have
already set
Press R on the projector for four times in
•
steps 4 and 5 above.
When the System Lock is set
• When System Lock is set, the keycode input
screen appears after the power is turned on.
When it appears, enter the right keycode to
start projection.
Input screen for keycode
System Lock

Keylock Function

Use this function to lock the operation buttons
on the projector.
Locking the Operation Buttons
1 1
Hold down ENTER on the
projector for about 5 seconds
while the projector is being
turned on.
• The Keylock function screen is displayed.
Use this function to lock the operation buttons
on the projector.
(Except STANDBY/ON button)
Note: You can release the keylock by holding
down ENTER on the projector for about 5 seconds.
Return
On
SEL./ADJ.
RETURN
2 2
Select "On", then press ENTER.
On-screen display
• The Keylock function does not affect the
operation with the remote control buttons.
• You cannot use the Keylock function while the
projector is warming up.
58
Taking the Keylock Off
Hold down ENTER on the projector for about
5 seconds.
On-screen display
– – – –
See "Using 3D Viewing Mode" on page
details.
See "Using 3D Viewing Mode" on page
details.
ENTER
END
Menu operation n Page
Info
• Even when Keylock function is set to "On",
STANDBY/ON on the projector can be used
to turn on and off the power.
• Keylock cannot be set while the projector is:
displaying the "Menu" screens, in Standby
mode, warming up, changing input signals,
operating the Auto Sync function, in Freeze
mode or on the "System Lock" screen during
warming up.
®
8 DLP
Link
®
9 DLP
Link
TM
67 for
TM
Invert
67 for
46