Dhcp Client Setting; Tcp/Ip Setting; Returning To Default Settings (Network); Restart Network Function - Sharp Conference Series Operation Manual

Setting Up the Projector Network Environment ("Net." Menu)
(Continued)

2 DHCP Client Setting

Connect the LAN cable before turning the
projector on. If not, the DHCP Client function
does not work.
Selectable items
On
Off
Select "On" for "DHCP Client". "Obtaining IP
Address..." appears, then the menu screen
appears. Confi rm the parameters of IP
Address, Subnet Mask and Gateway on the
TCP/IP screen.
If the DHCP server is not available, "Could not
obtain IP Address." appears.
In this case, set the TCP/IP manually. (See the
item 3.)

3 TCP/IP Setting

Set the TCP/IP manually.
1 1
Select "Off" for "DHCP Client",
then press ENTER.
2 2
Select "TCP/IP", then press
ENTER.
3 3 Enter "IP Address" using P, R, Q
and O, then press ENTER.
Setting the TCP/IP
IP Address
Subnet Mask
Gateway
4 4 Enter "Subnet Mask" using P, R,
Q and O, then press ENTER.
5 5 Enter "Gateway" using P, R, Q
and O, then press ENTER.
62
Description
Obtains confi guration
parameters for TCP/IP network
automatically.
Sets the TCP/IP manually.
Net.
1 9 2 . 1 6 8 . 1 5 0 . 0
2 5 5 . 2 5 5 . 2 5 5 . 0
0 0 0 . 0 0 0 . 0 0 0 . 0 0 0
Selectable items
IP Address
Subnet Mask
Gateway
Note
• Confi rm the existing network's segment (IP
address group) to avoid setting an IP address
that duplicates the IP addresses of other
network equipment or computers. If
"192.168.150.002" is not used in a network
with an IP address of "192.168.150.XXX", you
don't have to change the projector IP address.
• For details about each setting, consult your
network administrator.
4 Returning to Default
Settings (Network)
This function allows you to initialize the
Network settings you have made in the
projector.
Note
• If the values for IP Address, Subnet Mask or
Gateway of the projector have been returned
to the default settings, the computer cannot
0 2
be connected to the projector depending on
0 0
the computer's network settings.

5 Restart Network Function

Restarts the network function.
Perform this function when the projector
cannot be controlled via the network.
Menu operation n Page
Description
Factory default setting:
192.168.150.002
Enter an IP address appropriate
for the network.
Factory default setting:
255.255.255.000
Set the subnet mask to the same
as that of the computer and
equipment on the network.
Factory default setting: 000. 000.
000. 000
* When not in use, set to "000.
000. 000. 000".
46