Turning The Projector On/Off; Turning The Projector On; Turning The Power Off (Putting The Projector Into Standby Mode) - Sharp Conference Series Operation Manual

Turning the Projector On/Off

Turning the Projector On

Note that the connections to external
equipment and power outlet should be
done before performing the operations
written below. (See pages
Press STANDBY/ON on the projector
or ON on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projector
is ready to start operation.
Note
• About the Lamp Indicator
The lamp indicator illuminates to indicate the
status of the lamp.
Green: The lamp is on.
Blinking in green: The lamp is warming up.
Red: The lamp is shut down
abnormally or the lamp should be
replaced.
• When switching on the projector, a slight
fl ickering of the image may be experienced
within the fi rst minute after the lamp has been
illuminated. This is normal operation as the
lamp's control circuitry is stabilising the lamp
output characteristics. It should not be
regarded as faulty operation.
• If the projector is put into Standby mode and
immediately turned on again, the lamp may
take some time to start projection.
• When System Lock is set, the keycode input
box appears. To cancel the keycode setting,
input the keycode that you have already set.
See page 57 for details.
Turning the Power Off (Putting
the Projector into Standby Mode)
Press STANDBY/ON on the projector
or STANDBY on the remote control,
then press that button again while the
confi rmation message is displayed, to
put the projector into Standby mode.
• The projector cannot be turned on while cooling.
•
22 to 26.)
•
On-screen display (confi rmation message)
•
Info
When "Auto Restart" is set to "On":
If the power cord is unplugged from the outlet
or the breaker switch is turned off when the
projector is on, then the projector
automatically turns on when the power cord
is plugged into the AC outlet or the breaker
switch is turned on. (See page 56.)
English is the factory default language. If you
want to change the on-screen display to
another language, change the language
according to the procedure on page 55.
STANDBY/ON button
Info
Direct Power Off function:
You can unplug the power cord from the AC
outlet even if the cooling fan is still running.
Power indicator
Lamp indicator
STANDBY
button
ON button
27