In-System Serial Programming By Dataman-40Pro - Dataman -448PRO2 User Manual

In-system serial programming by
DATAMAN-40PRO
For general definition, recommendation and direction about ISP see section Common notes
/ ISP please.
Description of DATAMAN-40PRO ISP connector
As ISP connector is used 10 pins connector 1-1634689-0 from TE connectivity or other
compatible connector.
Specification of ISP connector pins depends on the device, which you want to program. You
can find it in the control SW for programmer (PG4UW), menu Device / Device Info (Ctrl+F1).
Be aware, the ISP programming way of respective device must be selected. It is indicated by
(ISP) suffix after name of selected device.
These specifications correspond with application notes published of device manufacturers.
Note: Pin no. 1 is signed by triangle scratch on ISP cable connectors.
As ISP connectors are used 10 pins connectors 09185107813 from Harting or other
compatible connector.
Warnings:
When you use DATAMAN-40PRO as ISP programmer, don't insert device to ZIF
socket.
When you program devices in ZIF socket, don't insert ISP cable to ISP connector.
Use only attached ISP cable. When you use other ISP cable (other material, length...),
programming may occur unreliable.
DATAMAN-40PRO can supply programmed device only, but target system cannot
supply DATAMAN-40PRO.
DATAMAN-40PRO apply programming voltage to target device and checks his value
(target system can modify programming voltage). If the programming voltage is different
as expected, no action with target device will be executed.
2 4 6
1 3 5
Front view at ISP connector of programmer.
DATAMAN-40PRO ISP cable
49
8 10
7 9
DATAMAN-40PRO