Table of Contents
Advertisement
Design and manufacturing conditions for the stand
Please hire an installation service provider (for a fee) for the design and manufacture of a customized stand to be
used for portrait projection. Please ensure that the design complies with the following conditions:
•
There are 3 ventilation holes at the bottom of the projector. These holes should remain unobstructed.
•
Use the 6 screw holes at the back of the projector to secure it to the stand.
Screw hole center dimension: 300 × 300 (pitch = 150) mm
Screw hole dimension on the projector: M4 with the maximum depth 16 mm
4 of the legs can be unscrewed for removal.
•
Horizontal adjustment mechanism (for example, bolts and nuts in 4 places)
•
Please design the stand so that it does not easily topple over.
Reference drawings
* The drawing showing the dimensional requirements is not an actual stand design drawing.
(Unit: mm)
Air intake
Air intake
Horizontal adjuster
[Front View]
6. Installation and Connections
124.5
150
150
[Side View]
156
Air intake
6 - M4 bolt
Air exhaust
Advertisement
Table of Contents
