Table of Contents
Advertisement
RESET
Reset the adjustment value that has been selected in GEOMETRIC CORRECTION (return to the initial value). It
becomes ineffective when [OFF] is selected for [MODE].
• The adjusted value can be reset also by pressing the 3D REFORM button for two seconds or longer on the remote
control.
[EDGE BLENDING]
This adjusts the edges (boundaries) of the projection screen when projecting high resolution videos using a combina-
tion of several projectors in the up, down, left and right positions.
MODE
This enables or disables the EDGE BLENDING function.
When MODE is set to ON, the TOP, BOTTOM, LEFT, RIGHT, BLACK LEVEL, and BLEND CURVE settings can be
adjusted.
TOP/BOTTOM/LEFT/RIGHT
This selects the EDGE BLENDING locations on the left, right, top and bottom on the screen.
The following settings can be adjusted when an item is selected. (→ page 75)
CONTROL �������������� Enable TOP, BOTTOM, LEFT and RIGHT functions�
MARKER ���������������� Set whether to display marker or not when adjusting the range and display position� When turned on, a
magenta marker for adjusting the range adjustment and a green marker for adjusting the display position
will be displayed�
RANGE ������������������� Adjust the range (width) of the edge blending�
POSITION �������������� Adjust the display position of the edge blending�
BLACK LEVEL
Divide the screen into nine parts and keep the black level uniform for each projector.
The nine divisions screens are TOP-LEFT, TOP-CENTER, TOP-RIGHT, CENTER-LEFT, CENTER, CENTER-RIGHT,
BOTTOM-LEFT, BOTTOM-CENTER and BOTTOM-RIGHT. (→ page 78)
BLEND CURVE
Set brightness for the EDGE BLENDING section.
111
5. Using On-Screen Menu
Advertisement
Table of Contents
