Table of Contents
Advertisement
Setting items
Description
Expert Setting
Reality
Adjusts the detail and noise processing of images. (Super-resolution function)
On: Adjusts the settings of "Reality Creation."
Creation
Resolution: When you increase the setting value, the texture and detail of the
image become sharper.
Noise Filtering: When you increase the setting value, the noise (picture
roughness) becomes less prominent.
Test: On/Off: Switches "On" and "Off" at a certain frequency to check the
effect of "Reality Creation." *2
Off: The "Reality Creation" function is not applied.
Contrast
Corrects the level of bright and dark parts automatically to optimize contrast
according to a scene. Increases image sharpness and makes image dynamic.
Enhancer
High/Middle/Low: You can adjust the contrast enhancer.
Off: The "Contrast Enhancer" function is not applied.
Gamma
2.2: Equivalent to a 2.2 gamma curve.
Mode
2.4: Equivalent to a 2.4 gamma curve.
Gamma 3: Applies a gamma curve that prioritizes the brightness to suit use in
a relatively bright environment.
Gamma 4: Enhances black and white contrast to suit use in a relatively dark
environment.
DICOM GSDF Sim.
Standard Display Function (GSDF) of the Digital Imaging and
Communications in Medicine (DICOM) standards.
Color
Converts the color space.
Space
Custom 1: Produces images with vivid colors.
Custom 2: Produces images with muted colors.
Custom 3: Reproduces image colors true to the original image source.
You can select R/G/B for the selected color space and adjust the R/G/B
chromaticity points in the x and y directions in the CIExy chromaticity diagram
respectively.
Color Select: Select the color to adjust from "Red," "Green," and "Blue."
Cyan - Red (x): Adjusts the chromaticity point of the selected color toward
cyan-red (x).
Magenta - Green (y): Adjusts the chromaticity point of the selected color
toward magenta-green (y).
Color
On: Adjusts the hue, saturation, and brightness for the selected color. Repeat
Correction
steps 1 and 2 described below to specify the target color.
1 Press V/v to select "Color Select," then press B/b to select the color you
2 Press V/v to select "Hue," "Saturation" or "Brightness," then adjust them
Off: The "Color Correction" function is not applied.
Film
Auto: Precisely reproduces the image from a film source to suit the original
*4 *5
film source. Normally, select this option.
Mode
Off: Select this option if the images are rough around the edges when "Auto" is
selected.
Notes
*1: The projector may not be able to maintain the brightness in an environment with a lot of dust and
dirt.
*3
: Gamma setting is in accordance with the Grayscale
want to adjust among "Red," "Yellow," "Green," "Cyan," "Blue," and
"Magenta."
to suit your taste using B/b while watching the projected picture.
26
Advertisement
Table of Contents
