Blending Projections From Multiple Projectors On A Screen - Sony VPL-FHZ61 Operating Instructions Manual

Note
*1: The setting may not be reset depending on
the combination of adjustment values of
the Screen Fitting setting items. In this
case, reset all of the Screen Fitting setting
items.
Blending Projections from
Multiple Projectors on a
Screen
1
Install the projectors.
Input a pattern, etc., to adjust the
projected positions from multiple
projectors.
2
Set the ID mode.
Set a different ID mode for each
projector (page 32).
3
Set the picture mode.
Set the picture mode of the multiple
projectors to "Multi Screen" (page 25).
4
Unify the color space.
Set the color space of the multiple
projectors to the same mode (Custom 1
to 3) (page 36). R/G/B can be finely
adjusted as necessary.
5
Adjust the color matching setting.
Finely adjust each tone as necessary
(page 36)
.
6
Set the Edge Blending setting.
When overlaying multiple projections,
the Edge Blending setting is available.
Select "Multi Screen" in the Installation
menu, then select "Edge Blending"
(page 36) .
7
Enable the Edge Blending function.
In "Blend Settings," set "Edge
Blending" to "On" for each blending
position.
8
Set the blending width.
Set the blending width according to the
overlapping range for the source signal.
Assign the width here.
9
Adjust using "Blend Fitting."
Finely adjust the overlapped area.
10
Adjust using "Zone Black Level Adj."
Adjust each correction zone by "Zone
Black Level Adj." for the most uniform
black level between each zone.
During this adjustment, a black image is
automatically projected.
Notes
• Depending on the blending start position or
the blending width, the menu may overlap
with the blending area and become invisible.
If you want to operate the projector while
viewing the menu, set "Edge Blending" to
"Off" once and make adjustments. Then, set
"Edge Blending" to "On."
• The procedure shown above is for general
guidance. Your own installation may vary
according to the situation.
• When multiple projectors are set up in a line,
the temperature inside the projectors may
increase due to exhaust vent proximity, and
an error indication may result.
In this case, space the projectors farther apart
and/or install deflection partitioning between
them.
For more details, consult with qualified Sony
personnel.
22