Subscribe to Our Youtube Channel
Related Manuals for Antari FT-55
Summary of Contents for Antari FT-55
- Page 1 FT-55 Fire Training Fog Machine User Manual English © 2018 Antari Lighting and Effects Ltd.
-
Page 3: Safety Information
Never add flammable liquid of any kind to the machine. ․ Make sure there are no flammable materials close to the machine while operating. ․ Only use Antari aerosols. Other aerosols may lead to heater clog and malfunction. ․ Remove aerosols after use. ․... -
Page 4: Unpacking And Inspection
If the machine fails to work, unplug the machine and stop operation immediately. ․ Contact your local Antari dealer for advice. Before transporting the machine, make sure the aerosols is removed ․ Fog fluid may present health risks if swallowed. Do not drink fog fluid. Store it securely. -
Page 5: Product Overview
Product Overview Aerosol Compartment Wire Remote Socket LED Indicator Power Switch Volume Control Knob Breaker Power Input Operation Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm open space around the machine. Step 2: Ensure that there are not any foreign objects in the threaded aerosol insert. - Page 6 requirement for the machine refer to the label on the back of the machine. Always connect the machine to a protected circuit and ensure it is properly grounded to avoid risk of electrocution. Step 4: Turn on the machine and allow it to heat up. Heat up takes approximatly 7.5 mintues. Once the machine has reached operating temperature, the LED inidcator located in the back panel will turn solid green.
- Page 7 Note: Wireless operation only available when machine connected to a power source. Off Power Operation FT-55 can operate plugged in once it has reached working temperature. The amount of smoke produced depends on its temperature cycle when it is disconnected. With a complete heating cycle the machine can generate smoke up to 45 minutes after disconnection.
-
Page 8: Service And Maintenance
Aerosols Only use Antari FLP-700 aerosol for the FT-55 Fire Training Fog Machine. The machine is tested and calibrated with this aerosol to get the best output performance. Warranty will be voided if any other type of aerosol is used, improper use of aerosol may lead to machine failure or malfunction. -
Page 9: Technical Specifications
EU model : AC 220-240V, 50 / 60Hz 8A Rated power 1450W Warm-up time 7.5 minutes (approx.) Fluid consumption 110 ml/min Compatible fluid Antari FLP aerosol Ambient temp. range 0 °C - 40 °C (32 °F-104 °F) Output 20,000 ft /min (566 m /min) Control... - Page 12 C08FT0551...
Need help?
Do you have a question about the FT-55 and is the answer not in the manual?
Questions and answers