AC power and clean with a damp cloth. If fluid is spilled onto electronic parts, immediately unplug the machine and contact your local Antari dealer for advice. No user serviceable and modifiable parts inside. Never try to repair this product, an ․...
Contact your local Antari dealer for advice. Before transporting the machine, make sure the aerosols is removed ․ Fog fluid may present health risks if swallowed. Do not drink fog fluid. Store it securely. ․ In case of eye contact or if fluid is swallowed, immediately look for medical advice.
Product Overview Aerosol Compartment Wire Remote Socket LED Indicator Power Switch Volume Control Knob Breaker Power Input Operation Step 1: Place the machine on a flat surface and in a suitably large area with at least 50 cm open space around the machine. Step 2: Ensure that there are not any foreign objects in the threaded aerosol insert.
Page 6
requirement for the machine refer to the label on the back of the machine. Always connect the machine to a protected circuit and ensure it is properly grounded to avoid risk of electrocution. Step 4: Turn on the machine and allow it to heat up. Heat up takes approximatly 7.5 mintues.
Page 7
FT-55 might eject fluid when working temperature is not reached. Aerosols Only use Antari FLP-700 aerosol for the FT-55 Fire Training Fog Machine. The machine is tested and calibrated with this aerosol to get the best output performance. Warranty will be voided if any other type of aerosol is used, improper use of aerosol may lead to machine failure or malfunction.
Service and Maintenance Do not allow the machine to become contaminated. ․ Remove dust from air vents with air compressor, vacuum or a soft brush. ․ Only use a damp cloth to clean the casing. ․ Before storing run distilled water through the system to help avoid condensing the ․...
Need help?
Do you have a question about the 20210616 and is the answer not in the manual?
Questions and answers