Table of Contents
Advertisement
S
S
UPER
ERVER 6028R-TR/TRT User's Manual
DVD-ROM Drive (optional)
Power Supplies
6-2
Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the Control Panel PCB (printed circuit
board). Make sure the red wire plugs into pin 1 on both connectors. Pull all excess
cabling out of the airflow path. The LEDs inform you of system status.
See Chapter 3 for details on the LEDs and the control panel buttons. Details on
JF1 can be found in Chapter 5.
Figure 6-1. Front and Rear Chassis Views
USB Ports (2) COM Port
SATA Drives (8)
Rear I/O Ports (see Section 5-3)
System Reset
6-2
Control Panel
Main Power
Low-profile PCI Slots
Advertisement
Table of Contents
