Table of Contents
Advertisement
INSTALLATION
The standard fl ush door comes with a black frame. To install the frame,
simply hook the top door fl ange onto the top of the unit and swing the
door towards the unit, see Diagram 1.
NOTE: Install the Finishing Trim prior to installing the Flush Louvers.
1)
Install the Finishing Trim sides as shown in the diagram; line up the holes in the
side trim with the holes in the fi rebox side.
2)
Secure with 2 screws per side.
3)
Loosen the 2 screws in the top inside edge of the fi rebox.
4)
Slide the Finishing Trim Top over the Side Trim pieces and fi t the
bottom bracket slots over the screws. Tighten the 2 screws to
secure in place.
Finishing Trim
50
FLUSH GLASS DOOR INSTALLATION
Diagram 1
OPTIONAL FINISHING TRIM INSTALLATION
B41XT
43-3/8"
W
Edge of Unit
H
37-5/8"
Be careful that the glass gasket does not roll up; there must be a gap
between the gasket and the door lip to ensure that the door sits securely
on the unit, see Diagram 2.
Use the hook to pull the spring out until you can put the hook into the
slot on the bottom door bracket. Repeat for 2nd spring. See Diagram 3.
To remove the fl ush door, reverse the above steps.
B36XT
40-1/2"
35-3/4"
Diagram 2
Diagram 3
Finishing
Trim Top
Finishing
Trim Side
Regency Bellavista™ B41XT Gas Fireplace
Advertisement
Table of Contents
