Table of Contents
Advertisement
Home position
The home position is the camera's basic position.
The camera returns to this position whenever you want.
Use the following procedure to make the home position.
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use [Near] or [Far] button to set it ON.
3. Press [Open] or [Close] button.
4. Select [SET] option and then press [Open] or [Close]
button.
5. Select the home position where you want and then
press [Open] or [Close] button.
6. Select [DWELL TIME] option and then select the dwell
time.
7. Select [RETURN] option and press [Open] or [Close]
button to exit the setting menu.
Go to Home position
1. Select [HOME POSITION] option on the [SPECIAL]
menu.
2. Use [Near] or [Far] button to set it ON.
3. Press [Open] or [Close] button.
4. Select [GO] option and then press [Open] or [Close]
button. The camera will move to the home position.
NOTE
•
If you do not want to use the home position
function, set the [HOME POSITION] option to [OFF].
•
If you set the [HOME POSITION] to [ON], the [AUTO
RETURN] option is set to [OFF] automatically and you
can not use it.
Auto return
This function can be used to specify automatic return to a
particular mode if a certain amount of time elapses without
any operation being performed.
1. Select [AUTO RETURN] option on the [SPECIAL] menu.
2. Use [Near] or [Far] button to set it [ON] and then press
[Open] or [Close] button.
3. Select [RETURN TIME] option and then select the auto
return time.
4. Select [RETURN] option and press [Open] or [Close]
button to exit the setting menu.
NOTE
If you set [AUTO RETURN] to [ON], the [HOME POSITION]
option is set to [OFF] automatically and you can not use
it.
Tilt limit
You can specify the tilt range. If you set this function, the
camera is able to tilt from 15 º to 165 º .
1. Select [TILT LIMIT] option on the [SPECIAL] menu.
2. Use [Near] or [Far] button to set it [ON]. If you do not
want to use this function, set it to [OFF].
Communication
This setting is required to establish a connection between
the system controller and the camera.
1. Select [COMMUNICATION] option on the [SPECIAL]
menu.
2. Press [Open] or [Close] button.
3. Set the below options.
•
Protocol: This item lets you set a protocol for RS-485
communication. Select the desired protocol.
•
Baud Rate: Select the desired speed of
communication between the system controller
and the camera. Confirm selected parameter to the
baud rate of the system controller.
•
SAVE & EXIT: Select this option and then
press [Open] or [Close] button to save the
communication settings and exit the setting menu.
Auto Tracking setting
Configure Auto Tracking MENU options. These options are
used for tracking the displayed object in motion on the
screen. If you want to use the [Auto Tracking] option, use
[Near] or [Far] button to set it ON.
Operation
45
4
Advertisement
Table of Contents
