19
LHV2000 Series Hard Drive Installation
6. Connect the SATA power and data cable to the hard drive.
7. Replace the cover and cover screws (4x).
NOTE
After installation, you must format the hard drive in order to use it with the system. See 19.3 Format-
ting Hard Drives, page 186.
19.2 Removing the Hard Drive
19.2.1 LHV2104 / LHV2108 / LHV2116
CAUTION
Make sure that the system is OFF and ALL power adapters have been disconnected before removing/in-
stalling the hard drive.
1. Power off the system, and unplug all cabling from the system.
2. Remove the rear panel screws (4x) and side panel screws (1x on each side). Remove
the cover.
3. Turn the system over and loosen the hard drive screws (4x), but do not remove them.
#LX400060; r.36893/36903; en-US
184