Baumatic BHI900SS Instruction Manual page 23

o If the hob is being installed without an oven below it, a
separator panel must be placed between the bottom of the hob
and the housing below it, at a minimum distance of 10 mm.
o If the hob is being installed with an oven below it, place a
separator panel at a minimum distance of 15 mm and follow the
oven manufacturer's
aeration is provided.
o The heat produced by the oven, measured on the right side of
the bottom of the hob, must be lower than 60°C, otherwise the
heat could damage the touch control panel.
o IMPORTANT: You must observe the ventilation requirements
shown in the drawing below.
o Carefully turn the hob upside down and place it on a cushioned
mat.
o Apply the sealing strip provided (A) around the edge of the
appliance.
o The protective covering must be removed from both sides.
o Do not leave a gap in the sealing agent or overlap the thickness.
instructions, ensuring
23
that sufficient