Oki MC563 MFP User Manual page 169

Please open the Output Tray. 409:Rear Output Tray Error
The rear output tray was moved while duplex printing.
Close the rear output tray and remove the jammed paper remaining inside of the unit.
Toner Empty
The indicated cartridge ran out of toner.
Replace the empty toner cartridge with a new one.
Wait Timeout is disabled. If your printer is connected to USB port, it may become
unable to print a job without via the USB port.
Wait Timeout is disabled.
Press button, select [Setting] > [Admin Setup] > [Print Setup] > [Print menu] > [Printer Adjust] > [Timeout Injob]
on the operator panel, and then select a longer print timeout value.
Memory Overflow has occurred during Fax Tx reservation.
Insufficient memory error has occurred during Scan To fax.
Memory Overflow
Insufficient memory error has occurred during fax reception.
E-mail receiving has been cancelled.
Receiving E-mail was cancelled because the format of the E-mail is not supported or attached file is too large.
Check the file format and size of the attached file.
Wireless settings are incomplete.
Wrong values are set or items remain unset in the wireless LAN settings. Check the wireless settings.
Not connected to wireless access point.
No wireless LAN access points are found.
Make sure that the access point is turned on.
Disconnect and re-connect to wireless LAN.
Wireless startup failed.
Turn the machine off, check that the wireless LAN module is correctly installed, and then reboot the machine. If the
error persists, contact your dealer.
Firmware Update Error Please try again. If network doesn't work, please try firmware
update over USB.
Updating the firmware failed. Update again.
Caution, unknown Consumable detected Go to User Manual "Trouble Shooting" to
restore operation Error: 709
You can use any consumables in your product, but you must accept the risks of using non-genuine consumables.
If the use of non-genuine consumables causes damage to the product or results in your product not functioning to its
full specification, then such damage or effect on the product is not covered by warranty.
To accept these risks and to restore function;
(1) Turn off your product.
(2) Press and hold the
(3) After start up, release the
Note: This operation will be recorded for future reference.
[PAGES] Pages Left.
The image drum indicated on the screen reaches its lifetime.
Replace the image drum with a new one.
C: Cyan (blue), M: Magenta (red), Y: Yellow, K: Black
Image Drum Life. Print Quality Not Guaranteed.
The image drum indicated on the screen reaches its lifetime.
Replace the image drum with a new one.
C: Cyan (blue), M: Magenta (red), Y: Yellow, K: Black
Receiving data timeout.
Data could not received within a certain period of time.
Set a longer data reception timeout value.
- 169 -
(CLEAR) button and turn your product on.
(CLEAR) button.
9. Troubleshooting