Formatting Hard Drives - FLIR Lorex LNR400 Series Instruction Manual

20 LNR400 Series Hard Drive Installation
3. Turn the system over and loosen the hard drive screws (4x), but do not remove them.
4. Disconnect the SATA power and data cable from the hard drive.
5. Carefully turn the system over. Slide the hard drive and then lift it out of the system.
6. Replace the cover and cover screws (4x).
NOTE
After installation, you must format the hard drive in order to use it with the system. See 20.3 Format-
ting Hard Drives, page 162.

20.3 Formatting Hard Drives

You must format hard drives before you may use them with the system.
#LX400021; r.29578/29578; en-US
162