Front I/O Ports - Supermicro SuperServer 1019C-FHTN8 User Manual

SuperServer 1019C-FHTN8 User's Manual

4.3 Front I/O Ports

The following input/output ports are provided by the motherboard.
1
# Description
1 VGA Port
2 Dedicated IPMI LAN
3 USB1
4 USB0
5 USB5 (USB 3.1 Gen 1)
IPMI LAN Port
An IPMI-dedicated GbE LAN port is on the I/O panel. IPMI LAN is supported by the Aspeed
AST2500 BMC (Baseboard Management Controller). This port accepts a RJ45 type cable.
Refer to the LED Indicator Section for IPMI LAN LED information.
Universal Serial Bus (USB) Ports
There are two USB 3.1 Gen 1 ports (5/6) and two USB 2.0 ports (3/4).
Unit Identifier Switch/UID LED Indicator
A Unit Identifier (UID) Switch (UID-SW) and a rear LED Indicator (UID-LED) are located on
the I/O panel. When the user presses the UID switch, the UID LED indicator illuminates. Press
the UID switch again to turn off the UID LED. The UID indicator provides easy identification
of a system unit that might be in need of service.
Note: UID can also be triggered via IPMI on the motherboard. For more information on IPMI,
refer to the IPMI User's Guide posted on our website: http://www.supermicro.com.
2
11
5
3
7
4
6
Figure 4-2. Front I/O Ports
# Description
6 USB4 (USB 3.1 Gen 1)
7 LAN1
8 LAN2
9 LAN3
10 LAN4
56
12 13 14
8 9
10
# Description
11 LAN5
12 LAN6
13 LAN7
14 LAN8
15 UID Switch and UID LED
15