Table of Contents
Advertisement
Chapter 4: AMI BIOS
Bits per second
Use this item to set the transmission speed for a serial port used in
Console Redirection. Make sure that the same speed is used in the
host computer and the client computer. A lower transmission speed
may be required for long and busy lines. The options are 9600, 19200,
38400, 57600, and 115200 (bits per second).
Data Bits
Use this feature to set the data transmission size for Console Redirec-
tion. The options are 7 (Bits) and 8 (Bits).
Parity
A parity bit can be sent along with regular data bits to detect data
transmission errors. Select Even if the parity bit is set to 0, and the
number of 1's in data bits is even. Select Odd if the parity bit is set
to 0, and the number of 1's in data bits is odd. Select None if you
do not want to send a parity bit with your data bits in transmission.
Select Mark to add a mark as a parity bit to be sent along with the
data bits. Select Space to add a Space as a parity bit to be sent with
your data bits. The options are None, Even, Odd, Mark and Space.
Stop Bits
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit
for standard serial data communication. Select 2 Stop Bits if slower
devices are used. The options are 1 and 2.
Flow Control
Use this item to set the flow control for Console Redirection to pre-
vent data loss caused by buffer overflow. Send a "Stop" signal to stop
sending data when the receiving buffer is full. Send a "Start" signal
to start sending data when the receiving buffer is empty. The options
are None and Hardware RTS/CTS.
VT-UTF8 Combo Key Support
Select Enabled to enable VT-UTF8 Combination Key support for ANSI/
VT100 terminals. The options are Enabled (checked) and Disabled
(unchecked).
Recorder Mode
Select Enabled to capture the data displayed on a terminal and send
it as text messages to a remote server. The options are Enabled
(checked) and Disabled (unchecked).
4-33
Advertisement
Table of Contents
