Atag VA6611RT Use & Care Manual page 35

Installation and connection information
DISHWASHER CAvITY MEASUREMENTS
50-105 mm
WATER CONNECTION
• The machine can be connected to a cold or
hot water supply (maximum 85°C). However,
we recommend connection to a cold water
supply.
• The inlet pipe has a connector with either a 3/4"
internal thread.
ELECTRICAL CONNECTION
• 220­230VAC mains voltage, minimum 15A
DRAINAGE
• The supplied cone­shaped connection pipe
fits a drainage connection with an internal
diameter of 13, 16, 18 and 22 mm.
• Use a hose clamp if connecting to a fixed drain
(sink).
The connector is ready to cut to the desired drain
connection size. Only a clamp is required.
CABLE/HOSE LENGTHS
Drainage hose: 1930 mm
Supply hose: 1670 mm
Power cable: 1770 mm
Cable hole
38 mm
W = 600 mm
°C). However, C). However,
Make sure the edges of the
cable hole are even so as not to
damage the drainage and sup­
ply hoses and the electric cable.
DISHWASHER MEASUREMENTS
Min 823
*
*
With nut and sliding protection mounted
Recommended measurements
* *
TOOLS
1) Flathead screwdriver
2) Open­ended spanner 16 mm
3) Tape measure
4) Spirit level
100-
150