Table of Contents
Advertisement
About This Guide
This guide provides programming instructions for the EM3095. Users can configure the EM3095 by
scanning the programming barcodes included in this manual.
The EM3095 has been properly configured for most applications and can be put into use without further
configuration. Users may check the Factory Defaults Table in Appendix for reference. Throughout the
manual, programming barcodes marked with asterisks (**) are factory default values.
Connecting EVK and PC
The EVK tool is provided to assist users in application development for the EM3095. The EM3095 can be
connected to the EVK via a 12-pin flat flexible cable. Either USB connection or RS-232 connection can be
used when connecting the EVK to PC. A driver is required if EVK wants to communicate with EM3095
and receive decoded data through USB COM port.
Barcode Scanning
Powered by area-imaging technology and Newland patented
fast scanning and accurate decoding. Barcodes rotated at any angle can still be read with ease. When
scanning a barcode, simply center the aiming pattern projected by the EM3095 over the barcode.
Configuring the EM3095
There are two ways to configure the engine: barcode programming and command programming.
Barcode Programming
The EM3095 can be configured by scanning programming barcodes. All user programmable
features/options are described along with their programming barcodes/commands in the following
sections.
technology, the EM3095 features
2
Advertisement
Table of Contents
