Connection With The Mains; Operation; Stand Alone Operation; Master/Slave Operation - Future light EYE-19 User Manual

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.
On the rear panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture
until all fixtures are connected.
Please note: A maximum of 8 devices may be linked together. After every 8 devices, the fixtures must have

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the EYE-19 RGBW ZOOM starts running. During the Reset, the
motors are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the EYE-19 RGBW ZOOM can be used without controller. Disconnect the EYE-19
RGBW ZOOM from the controller and call the internal program. Please refer to the instructions under Control
Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave-devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master mode for the master device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
International
L
N
a renewed connection with the power mains.
41/56
00088949, Version 1.2