Fig. 23: Connecting The Speed Sensor; Fig. 24: Connecting The Compressor Cooling Air Intake - ABB HT610874 Operation Manual

Operation Manual / A130-M.. - A145-M..
3 Removing and Installing / 3.3 Installing the turbocharger
3.3.6 Connecting the turbocharger
Fig. 23: Connecting the speed sensor
Connect cable to speed sensor (86515).
u
Connect all gas, water and air lines according to the instructions of the enginebuilder.
u
Version with water-cooled bearing casing
Fit the water pipes according to the instructions of the enginebuilder.
u
Version with compressor wheel cooling
CAUTION
Failure of compressor wheel cooling
Any prolonged failure of the compressor wheel cooling will shorten the re-
placement interval of the compressor wheel.
Make sure there is an uninterrupted supply of cooling air during opera-
u
tion.
Fig. 24: Connecting the compressor cooling air intake
Remove the screw plug on the connection for the compressor wheel cooling (06) and fit
u
the cooling air line.
© Copyright 2022 ABB. All rights reserved. HZTL4031_EN Rev.P February 2022