Fig. 18: Fitting Threaded Rods Onto The Bracket; Fig. 19: Requirements For Threaded Rods; Table 5: Requirements For Threaded Rods - ABB HT610874 Operation Manual

Operation Manual / A130-M.. - A145-M..
3 Removing and Installing / 3.3 Installing the turbocharger
3.3.2 Fitting threaded rods
Fig. 18: Fitting threaded rods onto the bracket
1. Lightly oil the surfaces of the threaded rods (02) to be screwed in.
2. Screw the threaded rods into the bracket with the aid of locknuts (01).
3. Remove nuts (01) again.
Requirements for the threaded rods
Fig. 19: Requirements for threaded rods
Product Diameter
Threaded rod
[mm]
A130 Ø 16 / M16
A135 Ø 20 / M20
A140 Ø 24 / M24
A145 Ø 30 / M30
Table 5: Requirements for threaded rods
The threaded rods and nuts for fastening the turbocharger on the bracket are not included
in the Turbo Systems scope of delivery. The clamping nuts are included in the Turbo Systems
scope of delivery.
© Copyright 2022 ABB. All rights reserved.
Material Thread length
DIN / ISO 898 L1 [mm]
(Part 1)
10.9 / 12.9 ≥ 30
10.9 / 12.9 ≥ 30
10.9 / 12.9 ≥ 70
10.9 / 12.9 ≥ 80
HZTL4031_EN
Oil-cooled Water-cooled
L2 [mm] L2 [mm]
250 250
270 325
350 ... 360 410 ... 420
415 ... 425 --
Rev.P February 2022