Installing The Turbocharger; Fig. 17: Inserting Gaskets Into The Bracket - ABB HT610874 Operation Manual

Operation Manual / A130-M.. - A145-M..
3 Removing and Installing / 3.3 Installing the turbocharger
3.3

Installing the turbocharger

3.3.1 Inserting gaskets into the bracket
CAUTION
Inserting the gaskets
Gaskets that are forgotten, damaged or improperly inserted will lead to oil
leaks.
Always use new gaskets and insert them carefully into the slot.
u
The oil is supplied (02) and drained (03) through the bracket (01).
The necessary sealing is provided by O-rings. The O-rings are not included in the Turbo Sys-
tems scope of delivery.
Fig. 17: Inserting gaskets into the bracket
01 Bracket
02 Oil supply
03 Oil drain
Pin (06) as installation safety device
Turbochargers can have an oil inlet either on their right or left side; the oil inlet position can
be different for the turbocharger fitted on the left and on the right engine bank.
A pin can be installed in every support as an installation safety device to prevent inadvertent
incorrect fitting. This pin fits into the respective slot on the foot of the bearing casing. In-
structions of the enginebuilder must be observed.
© Copyright 2022 ABB. All rights reserved.
04 Slot for O-ring
05 O-rings
06 Pin (optional)
HZTL4031_EN Rev.P February 2022