Supermicro X11DGQ User Manual page 95

Chapter 4: UEFI BIOS
PCI Devices Option ROM Settings
Onboard NVME1/NVME2 OPROM
Select EFI to allow the user to boot the computer using an EFI (Extensible Firmware Interface)
device installed on the NVME connector specified by the user. Select Legacy to allow the
user to boot the computer using a legacy device installed on the NVME connector specified
by the user. The options are Disabled, Legacy, and EFI.
CPU2 Slot 1/CPU2 Slot 2/CPU1 Slot 3/CPU1 Slot 4/Slot 1 PCI-E x16 OPROM/CPU1
Slot 5/CPU2 Slot 5/Slot 1 PCI-E x16/Slot 2 PCI-E x8 (In 16)/PCH AOM
Select EFI to allow the user to boot the computer using an EFI (Extensible Firmware Interface)
device installed on the PCI-E slot specified by the user. Select Legacy to allow the user to
boot the computer using a legacy device installed on the PCI-E slot specified by the user. The
options are Disabled, Legacy, and EFI. (Note: Riser card names may differ in each system.)
Onboard Video OPROM (Option ROM)
Use this feature to select the Onboard Video Option ROM type. The options are Do Not
Launch, Legacy and UEFI.
Onboard LAN Device
Select Enable to use onboard LAN devices. The options are Disabled, Enabled, and Auto.
Onboard LAN1 Option ROM
Use this feature to select the type of device installed in LAN Port1, which will be used for
system boot. The options are Legacy, EFI and Disabled.
Onboard LAN2 Option ROM
Use this feature to select the type of device installed in LAN Port2, which will be used for
system boot. The options are Legacy, EFI and Disabled.
 Network Stack Configuration
Network Stack
Select Enabled to enable PXE (Preboot Execution Environment) or UEFI (Unified Extensible
Firmware Interface) for network stack support. The options are Enabled and Disabled.
*If "Network Stack" is set to Enabled, the following items will display:
Ipv4 PXE Support
Select Enabled to enable Ipv4 PXE boot support. If this feature is disabled, it will not create
the Ipv4 PXE boot option. The options are Disabled and Enabled.
95