ATTIX 791-2M/B1 1 Important safety instructions Symbols used to mark Before using the This symbol instructions vacuum cleaner, used mark always read the safety instruc- operating instruc- tions that must tions and keep be observed to them readily prevent damage available.
Page 5
ATTIX 791-2M/B1 Use the cleaner only if it is cer- the rate at which air is ex- tain that no active sources of changed in the room must be ignition can be sucked in. adequate if the exhaust air from...
Page 6
ATTIX 791-2M/B1 Arrange the electrical parts Observe the latest edition of the (sockets, plugs and couplings) IEC regulations. and lay down the extension lead so that the protection class is maintained. Never spray water on to the up- per section of the vacuum clean- er.
ATTIX 791-2M/B1 2 Description be fitted with appropriate filters. Purpose Depending on how hazardous See table in section 5.1.1. the dust is, the cleaner must 5 Filter for air supply to motor Operating elements See fold-out page at the front of 6 Retaining clamp these operating instructions.
ATTIX 791-2M/B1 To comply with regulations, only ap- 4.1.3 Connecting electrical 1. Ensure that the electrical proved dust producing tools should appliances appliance is switched off. be connected. 2. Connect the electrical appli- The maximum power consumption ance to the appliance socket of the connected power tool is stat- on the control panel.
ATTIX 791-2M/B1 Acoustic warning For safety reasons, an acoustic warning sounds if the air speed in the suction hose drops to be- low 20 m/s. See section “Trou- bleshooting”. 5 Applications and techniques Techniques If used correctly, additional ac- Effective cleaning is achieved if...
ATTIX 791-2M/B1 6 After finishing work Switching the vacuum 1. After picking up hazardous cleaner off and storage dust, vacuum clean the out- side of the cleaner. 2. Switch off the vacuum clean- er and pull the mains plug out of the socket.
ATTIX 791-2M/B1 1. Remove the upper section of 7.2.2 Replacing the waste cleaner from the dirt tank. 2. Open the retaining clamps (1) and remove the interme- diate ring (2) from the tank. 3. Close the waste bag using the cable binder (3).
ATTIX 791-2M/B1 5. Tip out the collected dirt. 6. Place the empty tank in the frame and close the locks (4). 7. Dispose of the dirt in accord- ance with legal regulations. 7.2.5 Replacing filter element 1. Open the retaining clamps 2.
ATTIX 791-2M/B1 8 Troubleshooting Fault Cause Remedy ‡ Motor does not start > Fuse of the mains socket has • Connect mains fuse. blown. > Overload protection switch • Switch off the vacuum cleaner has tripped. and allow it to cool for approx.
ATTIX 791-2M/B1 9 Further information Recycling the vacuum Make the old cleaner unusable and electronic appliances, used cleaner immediately. electrical goods must be col- 1. Unplug the cleaner and cut lected separately and recycled the power cord. ecologically. Do not discard of electrical ap- Contact your local authorities or pliances with household waste.