Table of Contents
Advertisement
ATTIX 791-2M/B1
7.2.5 Replacing filter element
breathing mask.
5
7.2.6 Replacing the filter for
air supply to motor
During the following
work,
dust is not unneces-
sarily spread around.
Wear a P2 breathing
mask.
10
1. Open the retaining clamps
During the follow-
ing work, ensure
that dust is not un-
necessarily spread
around. Wear a P2
1
3
2
ensure
that
5 5
4
4
4 4
5 5
and remove the upper sec-
tion of the cleaner from the
dirt tank. Lay the upper sec-
tion of the cleaner down with
the filter element facing up-
wards.
1
2
4
3
2
1
5. Tip out the collected dirt.
6. Place the empty tank in the
frame and close the locks
(4).
7. Dispose of the dirt in accord-
ance with legal regulations.
2. Turn the filter holder anti-
clockwise (1) and remove it
(2).
3. Place the protective filter
bag
1)
over the filter element
(3).
4. Carefully remove the filter
element and close the pro-
tective filter bag with a knot.
5. Clean the filter seal (4).
Check it for damage and
replace it if necessary.
6. Fit a new filter element.
7. Check that the float (5) works
properly. When the filter hold-
er is turned, the float inside
must move about easily.
4
8. Fit the filter holder and turn it
clockwise to secure it firmly.
9. Dispose of the used filter
element in accordance with
legal regulations.
Never use the vacuum cleaner
without a filter.
1. Loosen screws.
2. Remove the filter cassette
(1).
3. Remove the frame (2) with
filter felt (3) from the filter
holder (4).
4. Insert new filter felt and fix it
with frame.
5. Attach the filter cassette and
insert the screw again.
6. Dispose of used filter felt in
accordance with the regula-
tions.
1)
Accessory. Order No. shown in section 9.5.
Advertisement
Table of Contents
