After Finishing Work; Switching The Vacuum Cleaner Off And Storage; Maintenance; Maintenance Plan - Nilfisk-Advance ATTIX 791-2M/B1 Instructions For Use Manual

ATTIX 791-2M/B1

6 After finishing work

6.1 Switching the vacuum
cleaner off and storage

7 Maintenance

7.1

Maintenance plan

7.2.1 check the antistatic
Clamps
7.2.2 Replacing the waste bag
7.2.3 Replacing the filter bag
7.2.4 Emptying the dirt tank
7.2.5 Replacing filter element
7.2.6 Replace the filter for air
supply to motor
7.2

Maintenance work

7.2.1 check the antistatic
clamps
Do not use the cleaner with
damaged or missing antistatic
clamps. Risk of explosion due
to static discharge in explosive
atmospheres.
8
When replacing
the filter bag,
waste bag or filter
element

1
1
1. After picking up hazardous
dust, vacuum clean the out-
side of the cleaner.
2. Switch off the vacuum clean-
er and pull the mains plug
out of the socket.
3. Wind up the power cord and
hang it on the handle.
4. Empty the tank and clean the
vacuum cleaner.
5. After picking up liquids: Store
the upper section of the
cleaner separately so that
the filter element can dry.
6. Store the vacuum cleaner
in a dry room where it is
protected from unauthorized
use.
After finishing
work

1. Check the an-
1
1
1
As required




tistatic clamps
(1) for damage
and have them
replaced by
Nilfisk Service
if necessary.