Apron Threading Controls; Thread Dial - South bend SB1050F Manual

For Machines Mfg. Since 5/11

Apron Threading Controls

The half nut lever engages the carriage with
the leadscrew which moves the carriage and
cutting tool, along the length of the workpiece for
threading operations (see Figure 77).
Important: Make sure the feed selection lever
is in the disengaged (middle) position before
attempting to engage the half nut.
Feed Control
Lever
Cross Slide
Disengaged
Carriage
Feed Control
Lever
Figure 77. Apron threading controls.
O P E R A T I O N

Thread Dial

The numbers on the thread dial are used with
the thread dial chart to show when to engage the
half nut during inch threading. The thread dial
gear must be engaged with the leadscrew for this
to work. Loosen the knurled knob on the thread
dial, pivot the dial gear toward the leadscrew
so that it properly meshes with the leadscrew
threads, then re-tighten the knob, as shown
Figure 78.
Half Nut
Lever
Disengaged
Figure 78. Thread dial engaged with the leadscrew.
Halfnut
Lever
When threading, we recommend using the
slowest speed possible and avoiding deep
Engaged
cuts, so you are able to disengage the half nut
when required and prevent an apron crash!
13" Heavy 13
Knurled
Knob
Gearhead Lathe
®
Leadscrew
Dial Gear
-57-