Setting The Unit Up - ElectrIQ EGH20AWB User Manual

SETTING THE UNIT UP FOR USE
The appliance can be wall-mounted using the supplied mounting brackets, or alternatively
can be set up as a portable heater using the supplied legs and castors. It is important that
the unit is only operated if it is wall-mounted or has the castors fitted.
ATTACHING THE FEET
1. Turn the heater upside down.
2. Put the feet in position and align the
screws with the holes on the underside of
the feet.
3. Insert the screws into the feet, and fully
tighten.
4. After the installation is complete, turn the
heater the right way up.
WALL MOUNTING
The heater must be installed at least 15cm from the floor and 50cm from the ceiling.
IMPORTANT: Before drilling, ensure that no wires or pipelines are behind the wall to prevent
damage.
1. Measure the distance between the 3 wall
hanging holes on the rear of the heater
2. After double-checking the measurements mark
their position on the wall, using a pencil. We
would advise using a spirit level to ensure all
markings are square and level.
3. Once you are happy with the position of the
marks, drill 8mm diameter holes using a suitable
drill bit
4. Insert the wall plugs into the holes. Please note depending on the wall type; alternative
fixings may be required. Ask for professional advice if unsure.
5. Insert the supplied long screws into the wall plug ensuring that the screw head is
protruding by 5~10mm.
6. Hang the heater onto the screws, ensuring all screws engage with the relevant slot on
the rear of the heater.
7. Push the heater to the side so that screws move through the channel on the brackets to
secure it in position.
.
Page 5 of 23