Timer - ElectrIQ EGH20AWB User Manual

STANDBY TIMER
With the unit running with the desired settings, press the TIMER button. The countdown
timer symbol will illuminate and the unit will flash 00:00.
Repeatedly press the TIMER button to increase the duration of the timer (upto a maximum
of 24 hours).
Once the chosen timer length is selected, leave the unit, and after 10 seconds the timer will
start. After the chosen time period the heater will enter standby mode.
WEEKLY TIMER
Hold the PROGRAM button for 3 seconds to start the weekly timer. "Prog" will appear on
the display, signalling that the timer is active.
Press the TIMER button once, and the number "1" will begin to flash on the display to show
that the first day is selected. Use the UP and DOWN buttons to select the weekday to edit.
When you have selected the day to amend, press the TIMER button to confirm.
Each day has 6 time periods that can be programmed. Use the UP and DOWN buttons to
select the time period to adjust. Press the TIMER button to confirm the chosen time period.
The hours will begin to flash, and the symbol will be displayed. Adjust this using the UP
and DOWN buttons. Once the start hour is set, press the TIMER button and the minute value
will start to flash. Set this using the UP and DOWN buttons, before pressing the TIMER
button to confirm.
Once the start time has been set for the period of operation, the unit will then move onto
setting the finishing time. This will be indicated by the symbol on the display. This is set
in exactly the same way as the start time.
Once the TIMER button has been pressed to confirm the stop time the temperature display
will start to flash. Use the UP and DOWN buttons to confirm the desired temperature
during the period specified. The heater will only operate when the temperature is below
this value.
The above steps can then be repeated to set other time periods throughout the week.
The timer settings will be saved, and will not change as long as power is not disconnected
from the unit.
Page 9 of 23