Setting The Unit Up - ElectrIQ EAH2000W User Manual

SETTING THE UNIT UP FOR USE
The appliance can be wall-mounted using the supplied mounting brackets, or alternatively
can be set up as a portable heater using the supplied legs and castors. It is important that
the unit is only operated if it is wall-mounted or has the castors fitted.
WALL MOUNTING
Please note:
 A gap of 30cm should be left to both sides of the heater following installation
 It is the responsibility of the installer to ensure that the unit is securely installed.
1. Attach the 4 mounting brackets on to the rear of the heater
using the 8 small screws provided, ensuring that they are all
orientated so that the large hole in the bracket will be at the
base of the heater when mounted.
A
C
5. Insert the wall plugs into the holes. Please note depending on the wall type; alternative
fixings may be required. Ask for professional advice if unsure.
6. Insert the supplied long screws into the wall plug ensuring that the screw head is
protruding by 5~10mm.
7. Hang the heater onto the screws, ensuring all screws engage with the relevant slot on
the rear of the heater.
8. Push the heater to the side so that screws move through the channel on the brackets
to secure it in position.
FITTING THE CASTORS
1. Push the castors into position on the underside of the
legs.
2. Place the 2 legs in position on the underside of the
heater.
3. Secure them into position using 2 small screws for
each leg
2. Measure the distance between the wall hanging holes A
and B on the rear of the heater. Then measure the
B
distance between A and C.
3. After double-checking the measurements mark their
position on the wall, using a pencil. We would advise using
a spirit level to ensure all markings are square and level.
4. Once you are happy with the position of the marks, drill
8mm diameter holes using a suitable drill bit
Page 5 of 24
Bottom